粉刷石膏具有保水性优异、粘结性好、干缩率小、早强快硬等特点，解决了传统水泥砂浆抹灰的常见问题弊端，但是需要注意的是，在粉刷石膏施工过程仍需严格按施工规程进行，否则也会出现质量问题，下面济南石膏粉厂家来讲讲粉刷石膏施工及成品保护注意事项。

Plastering gypsum has the characteristics of excellent water retention, good cohesiveness, small drying shrinkage, early strength and quick hardening, which solves the common problems and drawbacks of traditional cement mortar plastering. However, it should be noted that the construction process of plastering gypsum still needs to be strictly in accordance with the construction procedures, otherwise there will be quality problems. Next, Jinan gypsum powder manufacturer will talk about the plastering gypsum construction and finished product protection precautions.

粉刷石膏施工注意事项

Precautions for plastering gypsum

1.掌握每批粉刷石膏的凝结时间，正确控制粉刷石膏抹灰料浆的拌和量，以免粉刷石膏浆料凝强后不能使用而造成浪费。注意已凝结或将要凝结的粉刷石膏料浆决不可再使用，因此在抹灰过程须随时把落地灰收回使用，以免浪费；

1. Grasp the setting time of each batch of plastered gypsum, and correctly control the mixing amount of plastered gypsum and plastering slurry, so as to avoid waste caused by the inability to use the plastered gypsum slurry after it is solidified. Note that the plastering gypsum slurry that has been set or will be set can never be used again, so the floor plaster must be recovered at any time during the plastering process to avoid waste;

2.为使粉刷石膏内的功能性外加剂得以充分溶解，一定要保证料浆制备过程的静置时间，避免上墙后因外加剂溶解不完全而使抹灰层出现气泡、空鼓等质量问题；

2. In order to fully dissolve the functional additives in the plastered gypsum, it is necessary to ensure the standing time of the slurry preparation process, and avoid the quality problems such as bubbles and hollows in the plastering layer caused by incomplete dissolution of the additives after the wall is installed;

3.施工的环境温度不低于0℃，并须粉刷石膏料浆不结冰和润湿后的墙面不结冰的情况下；

3. The ambient temperature for construction shall not be lower than 0 ℃, and the plastering gypsum slurry shall not freeze and the wetted wall shall not freeze;

4.袋装粉刷石膏在运输和储存过程中，应防止受潮，如发现有少量结块现象，可过筛过块状物除去，如结块大且量多，应停止使用，要求粉刷石膏生产厂家进行推官；

4. The bagged plastered gypsum shall be protected from moisture during transportation and storage. If a small amount of caking is found, it can be removed by sieving. If the caking is large and large, it shall be stopped. The plastered gypsum manufacturer is required to push the official;

5.拌制粉刷石膏料浆的容器及使用工具，在每次使用后都应洗刷干净，以免在下次的粉刷石膏料浆制备时有大块的砂石和石膏的硬化粒混入，影响操作及效果。

5. The containers and tools used for mixing plastered gypsum slurry shall be cleaned after each use to avoid the mixing of large pieces of sandstone and hardened particles of gypsum in the next preparation of plastered gypsum slurry, which will affect the operation and effect.

粉刷石膏石膏后成品保护

Finished product protection after plastering gypsum

1.在粉刷石膏抹灰层未凝结硬化前，应尽可能地遮接门窗口，避免通风使石膏失去足够水化的水。但当粉刷石膏凝结硬化以后，就应保持通风良好，使其尽快干燥，到达使用强度；

1. Before the plastering layer of plastered gypsum has not set and hardened, the door and window shall be covered as much as possible to prevent the gypsum from losing enough hydrated water due to ventilation. However, when the plaster is set and hardened, it should be well ventilated to dry it as soon as possible to reach the use intensity;

2.粉刷石膏抹灰层不得磕碰，且不能受锤击和刮划；

2. The gypsum plastering layer shall not be knocked, hammered or scratched;

3.不允许用水冲刷（包括由门窗口淋进的雨水），也应避免地面有积水而影响粉刷石膏抹灰层的干燥；

3. It is not allowed to wash with water (including rainwater from doors and windows), and it is also necessary to avoid water accumulation on the ground that will affect the dryness of the plastered gypsum plaster layer;

4.新抹粉刷石膏墙面不允许被热源直接烘烤。

4. The newly plastered gypsum wall is not allowed to be directly baked by the heat source.

粉刷石膏施工及成品保护注意事项就是以上所讲内容了，您对此有什么问题要咨询或者要需求要采购，可以随时来我们网站https://www.jnfhjc.com看看，有关人员竭诚为您服务！

Precautions for plastering gypsum construction and finished product protection are the above contents. If you have any questions or need to purchase, you can come to our website at any time https://www.jnfhjc.com Look, the relevant personnel will serve you wholeheartedly!