一、工艺腻子粉的使用方法

1、 Usage of process putty powder

1、基层应坚实、干净、大致平整、无明水，基层强度应大于或接近腻子的强度。

1. The base layer should be solid, clean, roughly flat, and free of open water. The strength of the base layer should be greater than or close to the strength of the putty.

2、吸水性强的基层应先用清水润湿或喷刷胶水进行封底处理后再刮腻子(稠度以适合施工为宜)。

2. The base layer with strong water absorption should be moistened with clean water or sprayed with adhesive for sealing treatment before scraping putty (the viscosity should be suitable for construction).

3、新抹灰的水泥墙应在养护期后再刮腻子。

3. Newly plastered cement walls should be putty applied after the curing period.

4、按腻子粉:水=1:0.5的比例搅拌均匀，静置10~20分钟再次搅拌均匀即可使用。

4. Mix evenly in a ratio of 1:0.5 putty powder to water, let it stand for 10-20 minutes, and then mix evenly again before use.

5、用钢刮板或抹刀按常规批刮，刮涂次数不可过多，通常批刮两次，第二次涂厚在前涂层干透情况下方可施工。

5. Use a steel scraper or spatula to scrape in regular batches, and the number of scrapings should not be too many. Usually, scrape twice in batches, and the second thick coating can only be applied after the previous coating is dry.

6、批刮厚度0.8~1.5mm，用量1~1.5ka/㎡，一般两遍成活。

6. The thickness of the batch scraping is 0.8-1.5mm, and the dosage is 1-1.5ka/m2. Generally, it is successful after two passes.

7、腻子干后，用320#或240#砂纸进行打磨，尽快涂刷涂料或粘贴墙纸。

7. After the putty is dry, polish it with 320 # or 240 # sandpaper and apply paint or wallpaper as soon as possible.

8、用量:在基层平整的情况下，每公斤腻子粉大约可批0.8-1.2平方米(二批)的平整墙面。

8. Dosage: With a flat base, approximately 0.8-1.2 square meters (two batches) of flat wall can be applied per kilogram of putty powder.

二、腻子粉使用注意事项

2、 Precautions for using putty powder

1、保存时，注意防水、防潮。贮存期六个月。

1. When storing, pay attention to waterproofing and moisture resistance. The storage period is six months.

2、施工温度在0℃℃以上，腻子粉调成膏状后应在4-5小时内使用，避免时间过长变质。

2. The construction temperature should be above 0 ℃, and the putty powder should be used within 4-5 hours after being mixed into a paste to avoid spoilage over time.

3、腻子粉不可与其它腻子在同一施工面使用，以免引起化学反应和色差。

3. Putty powder should not be used on the same construction surface as other putty to avoid chemical reactions and color differences.

三、腻子粉的作用

3、 The function of putty powder

1、腻子粉的主要原材料有漆基、填料和着色颜料等。漆基虽然是主料，但是用量较少。而填料则会大量使用，填料是滑石粉和碳酸钙等材料。颜料一般使用炭黑、铬黄和铁红等三种。

1. The main raw materials for putty powder include paint base, fillers, and coloring pigments. Although paint base is the main material, the amount used is relatively small. And fillers will be widely used, including materials such as talc powder and calcium carbonate. Pigments generally use three types: carbon black, chrome yellow, and iron red.

2、腻子粉的物理性状是膏状，产品可以直接使用，不需要自己再调配。一般使用刮刀刮涂腻子膏，施工工程简单方便，节约施工成本，效率比较高。

2. The physical properties of putty powder are paste like, and the product can be used directly without the need for self mixing. Generally, a scraper is used to apply putty, which makes the construction process simple and convenient, saves construction costs, and has a relatively high efficiency.

3、墙面基层上有凹陷之处时，就可使用腻子粉来进行找平，对后续工艺有很重要的影响。如果在涂刷涂料前未将基层处理好，那么油漆涂料很容易出现色差、开烈等情况，基层的凹凸不平也会直接反应在表层涂刷效果上。

3. When there are depressions on the base layer of the wall, putty powder can be used for leveling, which has a significant impact on the subsequent process. If the base layer is not properly treated before coating, the paint coating is prone to color difference, cracking, and other issues. The unevenness of the base layer will also be directly reflected in the surface coating effect.

本文由济南腻子粉提供技术支持，更多的详细精彩内容请点击我们的网站https://www.jnfhjc.com我们将会全心全意为您提供满意的服务。

This article is supported by Jinan Putty Powder. For more detailed and exciting content, please click on our website https://www.jnfhjc.com We will wholeheartedly provide you with satisfactory service.