济南腻子粉在使用过程中处理，而抛光时的时机把控尤为关键，不少人对此并不熟悉。济南腻子粉该如何掌握抛光方法？下面为大家介绍相关知识。

　　Jinan putty powder is processed during use, and the timing of polishing is particularly crucial, which many people are not familiar with. How to master the polishing method of Jinan putty powder? Below, we will introduce relevant knowledge to everyone.

　　并非所有腻子都适合抛光，济南地区常用的可抛光腻子多为仿瓷涂料或耐水腻子。施工时先批刮一遍腻子罩面找平，待干燥后用砂纸打磨，再批刮第二遍，待其八成干时用批刀将表面压平并磨出光泽即可。

　　Not all putty is suitable for polishing, and the commonly used polishable putty in Jinan area is mostly porcelain like coating or water-resistant putty. During construction, first apply a layer of putty to level the surface. After it dries, use sandpaper to polish it, and then apply a second layer of putty. When it is 80% dry, use a trowel to flatten the surface and polish it to a glossy finish.

　　内墙腻子面层抛光需把握合适时机，最佳时段是腻子表面水印消失后，立即进行抛光操作。

　　The polishing of the inner wall putty surface layer should be done at the appropriate time, and the best time is to immediately carry out the polishing operation after the watermark on the putty surface disappears.

　　产品务必在保质期内使用，若超过保质期，必须先进行试刮，检验合格后方可施工。

　　The product must be used within its shelf life. If it exceeds the shelf life, it must be scraped and inspected before construction can begin.

　　产品需注意防水，应存放在阴凉干燥处，且保证包装完好。

　　The product should be waterproof, stored in a cool and dry place, and ensure that the packaging is intact.

　　夏季或高温天气下，施刮腻子前建议先用清水润湿墙面，待墙面表面无明水后再进行腻子施刮。

　　In summer or hot weather, it is recommended to wet the wall with clean water before applying putty. Wait until there is no visible water on the wall surface before applying putty.

　　墙面刮过济南腻子粉干燥后若出现暗黄状态，可用抛光机抛光一次，再用砂纸打磨，重复三次，最后用抛光机抛光无需砂纸打磨。新的抛光操作需用 500 目的细砂纸加水打磨；腻子刮好后在七成多干时抛光一次，待九成干（从侧面看部分墙面干透略显发白）时再抛光一次，基本就能达到光亮效果。其实只要进行抛光通常都会有光泽，只是从侧面观察更为明显，操作得当便能实现既光亮又顺滑的效果。

　　If the wall surface appears dark yellow after being scraped with Jinan putty powder and dried, it can be polished once with a polishing machine, then sanded with sandpaper, repeated three times, and finally polished with a polishing machine without sandpaper. The new polishing operation requires 500 grit fine sandpaper and water to polish; After scraping the putty, polish it once when it is over 70% dry, and then polish it again when it is 90% dry (some walls appear slightly white when viewed from the side), which can basically achieve a bright effect. In fact, as long as polishing is carried out, there is usually a luster, but it is more obvious from the side view. Proper operation can achieve both a bright and smooth effect.

　　济南腻子粉的调配较为简单，需搭配液体进行。如今许多防水腻子粉只需用清水调配，使用方便；还有一种耐水性较差的腻子粉，需加入胶水调配，但这类胶水环保性欠佳，因此建议购买无需添加胶水的腻子粉。腻子粉的搅拌也很重要，需把握好搅拌时间和力度。腻子充分搅拌后，要静置 15-20 分钟，让其中的添加剂充分溶解。

　　The mixing of Jinan putty powder is relatively simple and requires the use of a liquid. Nowadays, many waterproof putty powders only need to be mixed with clean water, which is convenient to use; There is also a type of putty powder with poor water resistance that needs to be mixed with glue, but this type of glue has poor environmental protection. Therefore, it is recommended to purchase putty powder that does not require glue. The mixing of putty powder is also important, and it is necessary to grasp the mixing time and intensity. After the putty is fully mixed, it should be left to stand for 15-20 minutes to allow the additives to dissolve completely.

　　济南腻子粉作为建筑装修材料的一种，主要成分包含滑石粉等。新房毛坯房表面的一层白色物质便是腻子，通常腻子的白度在 90 以上，细度在 330 以上。腻子用于墙面修补找平，为后续装修（如刷油漆、贴壁纸）打下良好基础。腻子分为内墙和外墙两种，外墙腻子因需抵御风吹日晒，胶性大、强度高，环保指数稍低；内墙腻子综合性能较好，健康环保，因此内墙不外用，外墙不内用。

　　Jinan putty powder, as a type of building decoration material, mainly consists of talcum powder and other components. The layer of white substance on the surface of a new bare house is putty, usually with a whiteness of 90 or above and a fineness of 330 or above. Putty is used for wall repair and leveling, laying a good foundation for subsequent decoration such as painting and wallpaper. Putty is divided into two types: interior wall putty and exterior wall putty. Exterior wall putty needs to withstand wind and sun exposure, has high adhesive properties, high strength, and slightly lower environmental protection index; Interior wall putty has good comprehensive performance, is healthy and environmentally friendly, so it is not used externally for interior walls and not used internally for exterior walls.

　　通常腻子以石膏或水泥为基料，表面粗糙，便于粘接牢固。但施工时仍需在基层涂刷一层界面剂，以封固基层并提高墙面附着力，让腻子更好地粘结在基面上。

　　Usually, putty is based on gypsum or cement, with a rough surface that is easy to bond firmly. But during construction, it is still necessary to apply a layer of interface agent on the base layer to seal it and improve the adhesion of the wall, so that the putty can better bond to the base surface.

　　本文由济南腻子粉友情奉献.更多有关的知识请点击:http://www.jnfhjc.com真诚的态度.为您提供为全面的服务.更多有关的知识我们将会陆续向大家奉献.敬请期待.

　　This article is a friendly contribution from Jinan gypsum powder For more information, please click: http://www.jnfhjc.com Sincere attitude To provide you with comprehensive services We will gradually contribute more relevant knowledge to everyone Coming soon.